Key takeaways
- Set work height relative to the worker’s elbow height and the type of task — not a single “standard” bench height.
- Keep frequently used parts and tools in the primary reach zone, close to the body and in front of the worker.
- Design for the range of people who will use the station (e.g. 5th to 95th percentile) and add adjustability where possible.
- Simple changes — tilting fixtures, angled bins, tool balancers — often move a RULA score down by one or two action levels.
Fit the job to the worker
Good workstation design starts with anthropometry — the body dimensions of the people who will use it. A fixed bench height that suits a tall operator forces a shorter one to raise their shoulders; a height that suits a short operator forces a taller one to bend the neck and trunk. Both show up as higher RULA scores.
Recommended work heights
| Type of work | Recommended height | Why |
|---|---|---|
| Precision work (fine assembly, inspection) | 5–10 cm above elbow height, with forearm support | Brings the work closer to the eyes and reduces neck flexion |
| Light assembly | 10–15 cm below elbow height | Lets upper arms hang relaxed with room for tools and parts |
| Heavy work with downward force | 15–40 cm below elbow height | Allows body weight to contribute to force |
Reach zones
- Primary zone — within the sweep of the forearms with elbows close to the body: place the most frequently used parts and tools here.
- Secondary zone — within full arm reach: occasional items only.
- Outside reach — requires leaning, twisting or stepping: avoid for anything used every cycle.
- Avoid reaches above shoulder height, behind the body or across the midline.
Parts presentation and layout
- Use angled bins and gravity-flow racks so parts slide toward the operator.
- Tilt or rotate fixtures to bring the work face toward the worker instead of bending the wrist.
- Suspend heavier tools from balancers to remove static holding load.
- Provide knee and toe clearance so operators can stand close to the bench.
- Offer sit-stand options or perching stools for long-duration tasks.
Practical checklist
- Measure elbow height of the shortest and tallest operators
- Classify the task as precision, light or heavy
- Map every cycle item into a reach zone
- Check for raised shoulders and neck flexion on video
- Verify improvement with a before/after RULA score